RTK glossary
RTK glossary: plain definitions of the terms used in RTK positioning and correction services, from ambiguity resolution to VRS, with links to the pages that cover each one in depth.
RTK positioning has its own vocabulary, and the same idea often goes by two names. Where a page covers a term in depth, its entry links there.
Ambiguity resolution
Ambiguity resolution is the step in which the receiver works out the whole number of carrier wavelengths between each satellite and its antenna. The receiver measures the fraction of a wavelength very precisely, but not the whole count. When the count is resolved, the receiver reaches a fixed solution.
Base station
A base station is a GNSS receiver on a precisely surveyed point that tracks the same satellites as your rover. Because its position is known, its observations reveal the errors in the satellite signals, and a correction service uses them to correct your position. In a network, base stations are often called reference stations.
Baseline
The baseline is the distance between your rover and the base station it is corrected from. In single-base RTK, accuracy degrades as the baseline grows, which is why single-base services state a range limit. Network RTK models the errors across the network, so accuracy depends far less on the distance to any one station.
Carrier phase
Carrier phase is a measurement of the satellite signal's carrier wave rather than the code it carries. It is precise to millimetres, which is what lets RTK reach centimetre accuracy once the ambiguities are resolved.
Caster
A caster is the NTRIP server that distributes correction streams over the internet. Your receiver connects to it with an address, a port and credentials, then picks a mountpoint. The RTK Premium caster is rtkpremium.xyz on port 2101. See What is NTRIP.
Constellation
A constellation is one satellite navigation system, such as GPS, GLONASS, Galileo or BeiDou. Tracking more constellations gives the receiver more satellites to work with, which helps under trees and between buildings. RTK Premium corrections support all four where the local network tracks them.
Correction age
Correction age is the time since the correction your receiver is using was generated, usually shown in seconds. A steady stream keeps it low. A rising correction age usually points to the data connection, and most receivers drop the fix once it passes a set limit.
DOP (dilution of precision)
DOP is a number that describes how well the visible satellites are spread across the sky. A low value means good geometry and a more reliable position, and a high value means the satellites are bunched together, as often happens under canopy or beside tall buildings. Receivers report it as PDOP, HDOP or VDOP for position, horizontal and vertical.
Ellipsoidal height
Ellipsoidal height is the height above the reference ellipsoid, a smooth mathematical model of the Earth's shape. It can differ from height above sea level by tens of metres, so a geoid model is needed to convert it. RTK corrections deliver ellipsoidal heights. See Ellipsoidal and orthometric heights.
Epoch
The epoch of a reference frame is the date its coordinates refer to. Tectonic plates move by a few centimetres a year, so a point's coordinates in a global frame change over time, and the epoch fixes them to one moment. RTK Premium states the epoch with each frame, for example NAD83(2011), epoch 2010.0.
ETRS89
ETRS89 is the European Terrestrial Reference System 1989. It moves with the stable part of the Eurasian plate, so coordinates in Europe barely change over the years. National systems across Europe, including those of Great Britain, France, Germany and the Netherlands, are defined from it. RTK Premium delivers ETRS89, realisation ETRF2000, epoch 2010.0, in Europe. See Reference frames and constellations.
False fix
A false fix happens when the receiver resolves the ambiguities to the wrong whole numbers and reports a fixed solution that is wrong, often by several centimetres or more. Multipath and poor satellite geometry make it more likely. Measuring a known point at the start of each job catches it. See Inconsistent RTK accuracy on site.
Fixed solution
A fixed solution, or fix, is the state in which the receiver has resolved the carrier-phase ambiguities and reaches centimetre accuracy. RTK Premium reaches under 1.5 cm horizontal, 2.5 cm vertical in a fixed solution. See Accuracy expectations.
FKP
FKP, from the German Flächenkorrekturparameter, is a network RTK method in which the network sends the corrections of one reference station together with parameters that describe how the errors change across the area. The rover uses those parameters to adjust the corrections for its own position.
Float solution
A float solution is the state in which the receiver uses corrections but has not yet resolved the ambiguities. Accuracy is typically at decimetre level. A receiver that stays in float for a long time usually has a poor sky view, a weak correction stream or a correction source that does not match its position.
GGA heartbeat
The GGA heartbeat is an NMEA message carrying your receiver's approximate position, sent to the caster when you connect and then every few seconds. Network RTK needs it to build the correction for where you are. If it stops on a moving rover, accuracy drifts as you travel. See Mountpoint selection and the GGA heartbeat.
Geoid
The geoid is the surface that approximates mean sea level across the whole Earth. A geoid model gives the separation between the ellipsoid and the geoid at each location, which converts ellipsoidal heights into heights above sea level. Each country publishes the model that matches its national height system.
GNSS
GNSS, or Global Navigation Satellite System, is the umbrella term for satellite positioning systems such as GPS, GLONASS, Galileo and BeiDou. A GNSS receiver can track several of them at once.
ITRF
The ITRF, or International Terrestrial Reference Frame, is the global reference frame maintained by the international geodetic community and updated in successive realisations such as ITRF2014 and ITRF2020. Coordinates in it change over time with plate motion, so they are always given with an epoch. RTK Premium delivers ITRF2008, epoch 2005.0, in Japan, and ITRF on request in the United States and Canada.
MAC (Master-Auxiliary Concept)
MAC is a network RTK method in which the network sends the full observations of one master station and the correction differences for the auxiliary stations around it. The rover then computes the network solution for its own position. RTCM 3.x includes messages for it.
Map projection
A map projection turns coordinates on the curved Earth into flat grid coordinates in metres. British National Grid, Lambert-93 in France and UTM are examples. Your field software applies the projection to the corrected position, together with any geoid model and site calibration.
Mountpoint
A mountpoint is a named correction stream on the caster. Your receiver picks one from the source table when it connects. COMMON is the general-purpose RTK Premium stream and suits most receivers. See Mountpoint selection and the GGA heartbeat.
MSM (Multiple Signal Messages)
MSM are the RTCM 3 messages that carry observations for every constellation and signal in one consistent format. They come in levels from MSM1 to MSM7, and higher levels carry more detail. Check which MSM levels your receiver supports when you choose a mountpoint.
Multipath
Multipath is the error caused when a satellite signal reflects off a building, vehicle, water or the ground before it reaches the antenna. The reflected signal travels further and distorts the measurement. A correction network cannot remove it, because it is local to your antenna, so antenna placement and sky view are the remedies.
NAD83(2011)
NAD83(2011) is the 2011 realisation of the North American Datum of 1983, fixed to the North American plate. Most US survey and GIS work runs in it. It differs from ITRF and WGS 84 by about 1 to 2 m horizontally. RTK Premium delivers NAD83(2011), epoch 2010.0, in the United States and NAD83(CSRS), epoch 2010.0, in Canada. See RTK corrections in the United States.
Network RTK
Network RTK, or NRTK, uses many reference stations to model the errors across a region, then builds a correction for the rover's position. Accuracy stays consistent across the network instead of degrading with distance from one base. VRS, FKP and MAC are the main methods. See What is network RTK and VRS?.
NMEA 0183
NMEA 0183 is the text-based standard that GNSS receivers use to output positions and status. Each line is a sentence with a type code, and GGA is the sentence that carries position, fix quality and the number of satellites.
NTRIP
NTRIP, Networked Transport of RTCM via Internet Protocol, is the standard protocol for streaming GNSS corrections over the internet. A caster serves the streams, and your receiver connects to it as a client over mobile data or Wi-Fi. See What is NTRIP.
Orthometric height
Orthometric height is the height above the geoid, which is close to height above mean sea level. National height systems give heights of this kind or of a closely related kind, and project drawings normally use them. See Ellipsoidal and orthometric heights.
OSR (Observation Space Representation)
OSR is the classic way of delivering corrections, in which the service sends observations or corrections for one location, such as a base station or a virtual reference station. RTK and network RTK streams over NTRIP are OSR. It contrasts with SSR.
PPP (Precise Point Positioning)
PPP corrects a receiver's position with precise satellite orbits and clocks rather than a nearby base, so it works almost anywhere. The trade-off is convergence: the position takes time to settle to centimetre or decimetre level after the receiver starts.
PPP-RTK
PPP-RTK adds regional atmospheric corrections to PPP so the position converges much faster. RTK Premium uses PPP-RTK as a horizontal fallback past the network edge, holding a fix of 3 to 7 cm horizontally up to about 100 km beyond it. See What happens when a correction network goes down.
Precision and accuracy
Precision is how closely repeated measurements agree with each other, and accuracy is how close they are to the true position. A position can be precise and still inaccurate, for example when the project and the corrections are in different reference frames. Testing against a surveyed point measures accuracy. See Testing a correction service.
Reference frame
A reference frame is the realisation of a coordinate system on the Earth, fixed by a set of stations with known coordinates. Coordinates are only comparable when they are in the same frame and epoch. See Reference frames and constellations.
Rover
A rover is the GNSS receiver that moves and receives corrections, such as a survey pole, a machine on site, a tractor or a drone.
RTCM 3.x
RTCM 3.x is the message standard for GNSS corrections, maintained by the Radio Technical Commission for Maritime Services. Almost every survey-grade receiver accepts it. RTK Premium delivers RTCM 3.x at 1 Hz.
RTK (Real-Time Kinematic)
RTK is a positioning technique that uses carrier-phase measurements and corrections from a base station or network to reach centimetre accuracy in real time. See What is RTK.
Single-base RTK
Single-base RTK corrects the rover from one base station. It is simple and works well close to the base, but accuracy degrades as the baseline grows, and the corrections stop when that base goes offline.
Source table
The source table is the list of mountpoints that a caster publishes. Your receiver fetches it once it has the caster address, port and credentials, and you pick a mountpoint from it.
SSR (State Space Representation)
SSR is a way of delivering corrections as models of the individual error sources, such as satellite orbits, clocks, signal biases and the atmosphere, valid over a wide area. PPP and PPP-RTK services use SSR, often over satellite or the internet.
Time to fix
Time to fix is how long the receiver takes from connecting to its first fixed solution. It depends on the sky view, the number of satellites tracked, the satellite geometry and the quality of the correction stream.
VRS (Virtual Reference Station)
VRS is a network RTK method in which the network uses the rover's GGA position to create a virtual base station close by, then sends its observations as if a real base stood there. The rover works as if it had a very short baseline. See What is network RTK and VRS?.
WGS 84
WGS 84 is the reference frame of the GPS system and is closely aligned with the ITRF. Many apps label every position WGS 84, whatever frame the corrections actually arrive in, so check the frame at each step of your workflow.
Premium Positioning terms
Eligible Area
An Eligible Area is an area served by redundant correction sources, as shown on the coverage map. The RTK Premium service level, 99.9% monthly availability with a refund of the monthly fee on a published scale, applies in Eligible Areas. See Service level agreement.
Smart failover
Smart failover is how RTK Premium keeps corrections flowing when a correction source drops: the service moves to the next network that covers your site. Your mountpoint and credentials stay the same, and the receiver may lose its fix briefly while the new source is engaged. See What happens when a correction network goes down.
Single-source area
A single-source area is an area that one correction network serves. RTK Premium runs there on a best-effort basis, like any single-network service, and the service level does not apply.
RTK Premium, RTK Core and RTK Access
RTK Premium is the multi-network service with smart failover and a written service level in Eligible Areas. RTK Core delivers network RTK from one network, without failover. RTK Access is designed for applications that need horizontal position only. See Products.
Last updated: 7 November 2026
Was this helpful?